The role of drop-out fuses10kV equipment can be installed on the high-voltage side of the transformer on the pole, where the transformer and capacitor are connected to the line. The drop-out fuse can effectively protect the circuit from overload and short-circuit. At the same time, it can also be installed at the end of a long line or on a branch line, which can provide extended protection for areas that cannot be protected by relays.
Contact Now
Fuse selection The selection of the fuse should ensure that the distribution transformer internal or the high and low voltage outlet pipe can be quickly fused when there is a short circuit. In practice, the following principles are often used for selection; if the capacity of the distribution transformer is below 160KV, the fuse should be 2-2% of the rated current of the transformer.
Contact Now
FN12-12 and FN12-12R combined apparatus are three-phase high-voltage switchgear with a rated voltage of 12KV and a rated frequency of 50Hz. They are used for breaking and closing load current, closed-loop current, no-load transformer and cable charging current, closing short circuit current, and load switches equipped with grounding switches.
Contact Now
Y. F series porcelain clad arrestersummaryThe arrester is the basis for insulation coordination of various electrical equipment (transformer, reactor, capacitor, engine, motor, PT, CT, circuit breaker, contactor, etc.) in the power system.
Contact Now
installation and use 1. The fuse allows horizontal or vertical installation 2. When the data of the melt tube does not match the voltage and rated current of the line, it must not be connected to the line for use. 3.
Contact Now
The main component of the metal oxide arrester's nonlinear resistance valve is zinc oxide, which has excellent nonlinear characteristics. Under normal operating voltage, the resistance value is very high, which is actually equivalent to an insulator. Under over-voltage, the resistance of the resistor is very small, and the residual voltage is very low. However, under normal operating voltage, the valve plate will deteriorate due to long-term power frequency voltage, which will cause changes in resistance characteristics and increase the leakage current flowing through the valve plate.
Contact Now
HJDW6 outdoor low-voltage knife switch is a single-phase AC 50HZ low-voltage switchgear, which is used in the power system with rated voltage of 0.5KV to connect or isolate the power supply when there is voltage and no load. The knife switch is operated with insulated hook bar The knife switch is a single-phase structure, and each phase is composed of a word mounting plate, a pillar insulator, a knife switch, a contact, etc. The upper end of the knife switch is provided with a fixed pull ring for opening and closing the insulating hook bar□ Operating environmenta.
Contact Now
Drop type (drop type, detachable type) lightning arrester is a distribution type zinc oxide lightning arrester that is modified and skillfully installed on the drop type mechanism of the drop type fuse, so that the lightning arrester can be easily detected, repaired and replaced with the help of an insulating switch lever under the condition of continuous power supply, which not only ensures the smoothness of the line, but also greatly reduces the work intensity and time of power maintenance personnel, It is especially suitable for places that are not suitable for power failure, such as post a
Contact Now
ZFN21-12D/630-20, ZFN21-12DR/T125-31.5 high-voltage vacuum load switch and combination apparatus are used in three-phase AC 10KV, 50Hz power distribution system. It has the advantages of compact structure, small volume, light weight, long service life, strong making and breaking capacity, safety and reliability, etc.
Contact Now
□ Technical standards The standard for product production is GB11032-2000 (eqvIE60099-4.1991) "AC gapless metal oxide arrester", JB/8952-20045 "composite metallization arrester for AC system with no gap in the jacket"□ Product model description □ Conditions of useYH |---- Composite jacket metal oxide arrester (HY is the old model) | Y is metal oxide surge arrester with porcelain jacket5 |---- Nominal discharge current KaW |---- Structural features W: No gap C: Series gap R: Parallel gapS |---- place of use S: Power distribution Z: Power
Contact Now
use environment a. The altitude does not exceed 1000 meters; b. The surrounding air environment has no conductive dust and no corrosive, flammable and explosive gases, etc.; c. Wind pressure does not exceed 100Pa (equivalent to wind speed 34m/S); d. The earthquake intensity does not exceed magnitude 8; e. The annual temperature difference ratio is within ±40°C.
Contact Now
Distribution ArresterProduct use conditions:a) Suitable for indoor and outdoor use;b) Ambient temperature -40°C~+40°C;c) The altitude does not exceed 3000m (the porcelain sleeve type does not exceed 1000m);d) The power frequency is not less than 48Hz and not more than 62 Hz;e) The long-term power frequency voltage applied between the arrester terminals does not exceed the continuous operating voltage of the arrester;f) Areas with an earthquake intensity of 8 degrees or below;g) The maximum wind speed shall not exceed 35m/s. Product Model Description:According to JB/T 8459-1996 "Surge
Contact Now
GN38-12KV series indoor disconnectors are designed and manufactured to meet the needs of compact and miniaturized development of fixed high-voltage cabinets and ring network cabinets. It has a three position structure, fully insulated bottom plate, and is equipped with coaxial locking and perfect mechanical interlocking mechanism, which is compact in shape.
Contact Now
GW9-10 outdoor high-voltage disconnector is a single-phase AC 50HZ high-voltage switchgear, which is used in the power system with the rated voltage of 10KV to connect or disconnect the power supply with voltage and without load.The disconnector is operated with insulating rod.□ Operating environmenta. Altitude not exceeding 1000mb. Ambient air temperature: upper limit+40 ° C, lower limit - 30 ° C in general areas, and - 40 ° C in alpine areasc. Wind pressure shall not exceed 700Pa (equivalent to wind speed of 34m/s)D. Seismic intensity shall not exceed 8 degreesE.
Contact Now
GN30-12 rotary indoor high-voltage disconnector is a new type of rotary contact disconnector. Its main structure is to fix two groups of insulators and contacts on the upper and lower planes of the three-phase common chassis, and to achieve switch on by rotating the contact.The GN30-12D switch is an additional form with grounding knife on the basis of the GN30-12 switch, which can meet the needs of different power systems. This product is compact in design, small in point space, strong in insulation capacity, and easy to install and adjust.
Contact Now
Due to electromagnetic induction, the metal shielding layer (or metal sheath) of long line high-voltage single core power cables generates induced voltage, which leads to aging of insulation and reduction of insulation grade, resulting in reduced cable life. Once the induced voltage exceeds the sheath breakdown voltage, the outer sheath is broken down, forming a multi-point grounding fault of single core cables.
Contact Now
It is mainly used for non-contact monitoring of dangerous gas leakage at industrial site. It can also be used for coal mine monitoring, high-voltage power transmission and transformation detection, subway safety monitoring, environmental protection and fire rescue.Types of industrial hazardous gases that can be monitored:Hydrogen sulfide, ammonia, propane, sulfur dioxide, methanol, ethylene, methane, sulfur hexafluoride, dichloromethane, ether.
Contact Now
Electrified railway is a railway with electric locomotive as the basic traction force. It is composed of electric locomotive and electric power supply system.The power supply of the electrified railway is from the national grid. The high-voltage alternating current from the State Grid is sent to the railway traction substation for the first time of voltage reduction, and then sent to the overhead contact system.
Contact Now
It can diagnose the fault of the thermal imager through the communication port of the thermal imaging system, locate the fault group components conveniently and quickly according to the built-in fault expert database, and greatly improve the maintenance efficiency of the fault thermal imager;Through the self-developed comprehensive performance test algorithm of thermal imager, it is convenient and accurate to test the performance parameters of thermal imager: minimum resolvable temperature difference (MRTD), minimum detectable temperature difference (mdtd), field of view (FOV), zero travel mom
Contact Now
Front discharge detector, power detector, mainboard detector, front discharge tooling cable, power tooling cable, mainboard tooling cable, scanner tooling cable, refrigerator, detector tooling cable, display detector, special tooling cable for thermal sensing head.1.Software version identification and software loading of thermal sensor head of thermal imager;2.Simulation control of thermal sensor head of thermal imager;3.Adjustment of internal parameters of thermal sensor head of thermal imager;4.Fault discrimination of thermal sensor head, display / controller and cable assembly of thermal im
Contact Now
The turret assembly of situational awareness system carries two photoelectric sensors, thermal imager and TV camera, for image acquisition. It also integrates GPS and electronic compass, which can solve the target and local position. It can ensure the stable scanning of circumferential view through the step-by-step scanning stability platform, realize panoramic imaging, and then communicate with the display and control terminal through the wireless or optical fiber transmission module inside the turret.
Contact Now
For border and coastal defense monitoring and important places, long-distance and ultra long-distance observation equipment is essential. Long focus and multi field of view infrared thermal imager products can well meet the needs of long-distance observation at night. The infrared optical system designed with long focus and multi field of view can not only meet the needs of target search, but also meet the needs of further observation.
Contact Now
The multifunctional handheld thermal imager has the functions of infrared, visible light observation, GPS positioning, orientation and laser ranging, and can realize the observation of targets in day and night and under adverse weather conditions
Contact Now
The uncooled infrared focal plane thermal camera core assembly is adopted, which has the characteristics of small volume, light weight, long action distance and easy operation. The product can be used day and night, and has the ability to penetrate smoke and fog. It can "see" the target through the jungle and some shelters. The product is suitable for aiming, observation and search.
Contact Now
