The role of drop-out fuses10kV equipment can be installed on the high-voltage side of the transformer on the pole, where the transformer and capacitor are connected to the line. The drop-out fuse can effectively protect the circuit from overload and short-circuit. At the same time, it can also be installed at the end of a long line or on a branch line, which can provide extended protection for areas that cannot be protected by relays.
Contact Now
Fuse selection The selection of the fuse should ensure that the distribution transformer internal or the high and low voltage outlet pipe can be quickly fused when there is a short circuit. In practice, the following principles are often used for selection; if the capacity of the distribution transformer is below 160KV, the fuse should be 2-2% of the rated current of the transformer.
Contact Now
installation and use 1. The fuse allows horizontal or vertical installation 2. When the data of the melt tube does not match the voltage and rated current of the line, it must not be connected to the line for use. 3.
Contact Now
FN12-12 and FN12-12R combined apparatus are three-phase high-voltage switchgear with a rated voltage of 12KV and a rated frequency of 50Hz. They are used for breaking and closing load current, closed-loop current, no-load transformer and cable charging current, closing short circuit current, and load switches equipped with grounding switches.
Contact Now
Drop type (drop type, detachable type) lightning arrester is a distribution type zinc oxide lightning arrester that is modified and skillfully installed on the drop type mechanism of the drop type fuse, so that the lightning arrester can be easily detected, repaired and replaced with the help of an insulating switch lever under the condition of continuous power supply, which not only ensures the smoothness of the line, but also greatly reduces the work intensity and time of power maintenance personnel, It is especially suitable for places that are not suitable for power failure, such as post a
Contact Now
ZFN21-12D/630-20, ZFN21-12DR/T125-31.5 high-voltage vacuum load switch and combination apparatus are used in three-phase AC 10KV, 50Hz power distribution system. It has the advantages of compact structure, small volume, light weight, long service life, strong making and breaking capacity, safety and reliability, etc.
Contact Now
use environment a. The altitude does not exceed 1000 meters; b. The surrounding air environment has no conductive dust and no corrosive, flammable and explosive gases, etc.; c. Wind pressure does not exceed 100Pa (equivalent to wind speed 34m/S); d. The earthquake intensity does not exceed magnitude 8; e. The annual temperature difference ratio is within ±40°C.
Contact Now
Front discharge detector, power detector, mainboard detector, front discharge tooling cable, power tooling cable, mainboard tooling cable, scanner tooling cable, refrigerator, detector tooling cable, display detector, special tooling cable for thermal sensing head.1.Software version identification and software loading of thermal sensor head of thermal imager;2.Simulation control of thermal sensor head of thermal imager;3.Adjustment of internal parameters of thermal sensor head of thermal imager;4.Fault discrimination of thermal sensor head, display / controller and cable assembly of thermal im
Contact Now
Composite sheathed metal zinc oxide arresterThe core working element of the product is made of multi-element metal oxide powder mainly composed of zinc oxide, which has excellent nonlinear volt ampere characteristics, fast steep wave response and large flow capacity. Products with gap adopt self blowing gap and pressure equalizing radiation structure, which reduces the dispersion of discharge and has small impact coefficient.The adoption of composite insulating jacket conforms to the development trend of miniaturization, security and maintenance free of international electric power products.
Contact Now
Electrified railway is a railway with electric locomotive as the basic traction force. It is composed of electric locomotive and electric power supply system.The power supply of the electrified railway is from the national grid. The high-voltage alternating current from the State Grid is sent to the railway traction substation for the first time of voltage reduction, and then sent to the overhead contact system.
Contact Now
1) It is used to protect electrical equipment from high transient over-voltage and limit the freewheeling time and the freewheeling amplitude.
Contact Now
The lightning arrester is connected between the cable and the earth, usually in parallel with the protected equipment. The lightning arrester can effectively protect communication equipment. Once abnormal voltage occurs, the lightning arrester will act to protect. When the communication cable or equipment is operating under normal working voltage, the arrester will not work and will be regarded as open circuit to the ground.
Contact Now
Glass Pin Insulator is extremely convenient for transportation and installation; it adopts non-breakthrough type design, no need to measure zero value during operation; reliable structure, no damage to the core bar, and can give full play to its mechanical strength.
Contact Now
Metal Oxide ResistorsThe metal oxide resistor is the core part of the lightning arrester. It uses zinc oxide as the main component, adding a small amount of bismuth oxide, cobalt oxide, chromium oxide, manganese carbonate, antimony oxide and other trace additives, and is sintered at high temperature. The microstructure of metal oxide resistors is mainly composed of zinc oxide grains, grain boundary layer and spinel phase.
Contact Now
The discharge counter for lightning arrester is a high-voltage electrical apparatus used to monitor the discharge action of lightning arrester. Its structure consists of nonlinear resistance, electromagnetic counter and some electronic components. Under normal operating voltage, the leakage current flowing through the counter is very small, and the counter does not act.
Contact Now
normal use conditionsAmbient air temperature: upper limit +40°C lower limit -25°CAltitude below 2000mRelative humidity: the daily average value is not greater than 95%, the monthly average value is not greater than 90%The surrounding air should be free from obvious pollution such as corrosive or flammable gas, water vapor, etc. No frequent violent vibration
Contact Now
Super second generation low light level image intensifiers: NT-3, cnt-4 and dnt-6 have greatly improved in signal-to-noise ratio, transmission and resolution, which makes them have higher spectral response in a wide wavelength range, and can obtain better contrast for various observation scenes, whether in jungle, desert, coast, water surface It has excellent observation effect under any background, such as snow. Dnt-6 image intensifier is equipped with power supply with automatic shutter characteristics, and can automatically adjust the gain.
Contact Now
It is mainly used to break and close the load current, overload current and short-circuit current of the power system. It is suitable for protection and control of substations, industrial and mining enterprises, and urban and rural distribution networks, especially for places with frequent operations and urban automatic distribution networks. This product is matched with the controller, which can meet the requirements of the distribution automation system, and can reliably and effectively complete the traditional recloser function.
Contact Now
The direct coupled low light level enhanced digital camera (idc1616) adopts the advanced image tube direct coupling technology to integrate the digital camera and image intensifier, forming a new generation of low illumination digital night vision equipment with compact structure, high sensitivity and clear imaging.
Contact Now
CMOS hand-held night vision instrument is a portable photoelectric night vision instrument, which can observe the target under all-weather conditions.
Contact Now
CMOS gun sight has the characteristics of all-weather operation, no night lighting, strong concealment, high reliability, long service life and low power consumption. It is suitable for observation and aiming in day and night, night or low illumination environment. high reliability, long service life and low power consumption.
Contact Now
Type B double tube binocular low light level observation mirror can assist pilots to directly observe the environment and search targets in the night, complete night takeoff and landing, formation flight, visual recognition of landmark landform, heaven and earth line, aerial reconnaissance and recognition, search and recognition of ground targets at low altitude, and cooperate with forward-looking infrared to search.
Contact Now
The general low light level gun sight is a sight with high definition, good combination of gun and mirror, strong adaptability, reliability and durability, stable performance, good man-machine efficiency and low cost. It is suitable for short-range accurate shooting at night and can solve the rapid aiming and accurate shooting at 25-100 meters at night. The fixture can be quickly changed to adapt to various gun types.
Contact Now
It integrates the functions of visible light CCD, laser ranging, GPS / Beidou Positioning second generation, electronic compass and data recording. It has the characteristics of low power consumption, small volume, light weight, compact structure, simple operation and portability to complete the detection, aiming, ranging and positioning of targets.
Contact Now
